Postal Remap ECU Form
Postal Remap ECU Service
Send Us Your ECU
The postal remap service is aimed at professionals and enthusiasts. It is particularly suited to independent mechanics. If you have diagnostic equipment and an understanding of the machinery you would like to modify, this service is for you.
Just complete the Postal Remap ECU form with as much information as possible and Agri Remaps will provide a quote and the necessary information for both Pre and Post Remap.
PLEASE SEE FURTHER INFORMATION BELOW FORM.
Please Read The Following Information
About AGR ECU Remaps
Power Maps are available in Stages to suit requirements, and are relatively straight forward if you are able to locate, remove and refit an ECU.
Economy Maps again are relatively straight forward if you are able to locate, remove and refit an ECU.
Adblue Deletes for off-road use often require the electrical disconnection of the pump and usually allow for the disconnection of other related sensors too if needed.
EGR Deletes for off-road use usually require the electrical disconnection of the EGR Valve. In most cases It also allows you blank and remove the EGR valve if required and additionally remove the EGR Cooler or disconnect the Coolers coolant feed in the case of a EGR coolant leak.
DPF Deletes for off-road use are a little more involved, Soot and Ash level resets will be required using diagnostic software, the centre of the DPF will need removing to prevent blockage, Sensors may need disconnecting or resistors installing. (Resistors will be supplied with instructions if needed)
What ECU mapping solutions do you offer?
Different manufacturers require different solutions so its always worth checking requirements beforehand.
The more information you can provide, the more accurate quote and additional information AGR can provide.This is a frequently asked question?
Please note:
Some ECUs will require specific resets either before or after reprogramming but all information will be provided before booking in of the ECU.
ECU Removal Guide & Packaging Guide
Ignition off for minimum 2 mins
Disconnect the battery
Locate and disconnect ECU plugs, being careful not to damage the connector mechanisms. Look out for locks and if they are very tight use some WD40 to help release them.
Some ECUs may have anti tamper bolts/frames these will require the anti tamper bolts drilling out or the frames cutting away to allow the eco to be accessed and removed.
Sending Us Your ECU
Once removed, please pack the ECU well ideally in bubble wrap or similar ensuring no damage to the pins inside the plug. Please send using a signed for and insured service.
What happens once we receive your ECU
Upon arrival the ECU will be visually checked, tested and logged. If no issues are found your ECU will be programmed the same day as arrival and sent back out the next working day.