Fendt Vario Transmission

If you’ve had your Fendt tractor with a Fendt Vario transmission remapped you will only get limited power to the wheels through the transmission, though the initial and mid pull will be improved slightly, the heavy loads and hill work will be limited by reaching a certain fuel consumption figure (l/h Engine size dependent). Full power will be available to the PTO and there will be less drop off of power during PTO work to the wheels due to there being more available up to the point of the limit but If you want all the available power to the wheels you need a Power Hold Emulator. AGR can now provide Power Hold Emulators to fit all Fendt Vario Transmissions. The Emulator allows full power from the engine to the wheels in all conditions. The Fendt Vario Power Hold Emulators are plug and play and easily fitted.

SHOP NOW

What do the emulators do for your Fendt?

Often you will notice that on long or steep hills with heavy loads the power through the Vario transmission dies off instead of staying constant. The Fendt Vario Gearbox emulator allows a constant pull, allowing the transmission to use all the available engine power without overloading the transmission. The Power Hold Emulator also allows improved acceleration when peak power is required.
If you check the l/h consumption you will see they are capped as standard, when accelerating with a load the l/h fuel usage will hit a peak limit meaning acceleration is limited and as load increases this cap will be reached again meaning the speed starts to decrease. Once you are at cruising speed the l/h will drop to the standard rate.

As well as road work and carting, the Power Hold Emulators are particularly noticeable when using implements with high PTO power usage, such as big square balers etc. Each time the plunger compresses the PTO power demand can take the l/h to its limit (depending on the tractor size) reducing the power to the Vario Transmission and slowing forward speed, the emulators help reduce the lurch and maintain smoother operation.
As with all Transmissions Vario or not I understand the concern for damage and reliability. Most Fendt Vario Transmission damage these days is usually a result of misuse. Damage often occurs when being used heavily for breaking with large loads, pulling back sharply on the joystick or letting the engine try to slow the tractor without using the brakes properly, or poor maintenance. Obviously some failures are mechanical or down to wear, even faults or faulty components, but those are unavoidable emulator or not. Its also important to remember to carry out draft work and general field work in low ratio and rather than high even though the tractor may seem like it can handle it.
The extra power the emulator allows is a gradual increase when needed not a sudden step, surge or massive increase in power.
If you are looking to get the most out of your Fendt Remap the Power Hold Emulators are a must have, allowing you to use all the horsepower when needed, Transforming your Fendt
These are currently made to order and have large demand so please get in touch for an approx delivery date.

Contact Us

Fendt 942 Vario Transmission
Fendt 724 Vario Transmission
Fendt 828 Vario Transmission
Fendt 716 Vario Transmission
Fendt 720 Vario Transmission